|
1
|
| ID | MA39853 |
| Make | Nittan ,Japan |
| Model | |
| YOM | |
| Condition | Good Condition |
| Photo | See Photo
|
6 Ton Hammer Line Hydraulic
Based on the document provided, here is a transcription and translation of the technical specifications and installation instructions for the 6-ton hydraulic hammer system.
5. Operating System
The operating system is a modification of the existing control system. The control system is connected to the shaft of the main operation valve; by operating the connecting rod and the existing handles, various operations can be performed.
III. Main Technical Specifications
Item Value Unit
Weight of the falling part 6000kg
Impact energy :125kJ
Stroke :1300 mm
Impact frequency :5 sec
5 hits
Main cylinder pressure 2–4 MPa
Working pressure 9–14 MPa
Total pump flow rate
L/min
Main motor power
kW
Electric chiller 120,000 kcal/h
IV. Installation and Inspection
1. Installation
Remove existing steam hammer components such as the pneumatic cylinder, hammer head, and hammer rod.
Adjust the guide rails and install the new hammer head.
Install the connecting plate.
Install the support frame.
Install the link cylinder girder, install the cushion pads according to the drawing, and install the connection bolts and springs.
Install the hammer rod, bottom cover, and cushion piston.
Connect the hammer rod and hammer head according to the drawing.
Install the operating structures.
Note: This document appears to outline the conversion process of an older steam hammer into a more modern hydraulic system. Ensure all installations follow the specific technical drawings mentioned in steps 5 and 7 for safety and alignment.
Trimming Press
Kurimotto-S2-1000
Model(2point Crankles Types):S2-1000
Capacity (above deadpoint 10mm):1000 Tons
Stroke:300 mm
No ,Strokes per minute:30 spm
shut Height:850 mm
Ram Adjustment:300 mm
Table Area (L-R*F-B):2000*1600 mm
Ram Face(L-R*F-B):1800*1600mm
Die Cushion
Type;One Pad/One Cylinder:1set
Capacity*stroke:40 tons*100mm
Pad Area :1000 mm
Main Motor:55 kw
Ram Adjust Motor:3.7 Kw
Required air pressure:5kgcm2
2.5 Ton Hammer
Technical Specifications
Hit Energy :75 kj
Rated weight of the falling part:2500kg
Max Stroke:1350 mm
Hit Frequency :65 hits Min-1
Pump Specifications:A2F160R2P3 L
Working Air Pressure:140-150 kg/cm2
Main Motor Power:440V/55 kw*2
Cooling Tower:TY-30T(30RT)
Frame Frame Weight:28000 Kg
Hammer(Frame+Ram+Gurder+Rod+Head+Cylinder):36000 kg |
|
